058f Pid 1234 Full |best| - Usb Device Id Vid
Understanding what this hardware ID represents, why it appears, and how to use mass production tools (MPTools) will help you successfully flash and revive your bricked flash drive. 🛠️ Anatomy of the Identifier: VID 058F & PID 1234
Thus, means: An Alcor Micro Corp. USB Hub or Card Reader.
This ID is often seen in high-volume, generic flash drives. Because these IDs are programmable, they are sometimes found on "fake" or counterfeit drives where the reported capacity (e.g., 32GB) does not match the actual physical NAND flash storage.
Every USB hardware component relies on paired identification codes to tell the host operating system what drivers to load.
According to databases like DeviceHunt and speed test records from NirSoft , here are the standard details for this device: 058F (Alcor Micro Corp.). usb device id vid 058f pid 1234 full
The USB device identifier signifies a flash memory drive powered by an Alcor Micro Corporation controller chip that has entered a generic or hardware-fault state. When a flash drive exhibits these exact hardware IDs, it usually indicates that the controller chip cannot read its flash memory firmware, forcing it into a basic fail-safe mode.
Note: Do not unplug the drive during this process. The process can take anywhere from 5 to 45 minutes depending on the total capacity of your drive. Troubleshooting Common Flashing Failures Error Code / Behavior Probable Cause Corrective Action
The USB device identified with and Product ID (PID) 1234 is a generic mass storage device, typically a USB flash drive, manufactured by Alcor Micro Corp. . Device Identification Vendor: Alcor Micro Corp. Device Type: USB Mass Storage Device (Flash Drive) Controller: Often uses Alcor controllers such as the , , or . Interface: USB 2.0 (High Speed). Current: Typically 100mA. Typical Specifications
You will typically experience this issue in a few distinct ways: Understanding what this hardware ID represents, why it
When a drive shows this PID, it may appear as "Generic USB Flash Disk" with 0MB capacity or be marked as "Write Protected". Why Is My Device Showing This ID?
Cross-testing can help identify whether the issue is software or hardware-related:
The controller firmware is corrupted or the flash memory chip is damaged.
When you connect a flash drive to a PC, the operating system reads its hardware identifiers to assign drivers: This ID is often seen in high-volume, generic flash drives
Identifies the manufacturer as Alcor Micro Corp. , a major Taiwanese developer of USB hub and flash memory controller chips.
Budget USB 2.0 flash drives, branded promotional drives, or multi-card readers.
The points directly to Alcor Micro Corp. , a major manufacturer of flash memory controllers. Meanwhile, PID 1234 is a generic placeholder code. It indicates that the flash drive's microcontroller has lost its configuration or entered a fail-safe / fallback mode .
