Hw 130 Motor Control Shield For Arduino Datasheet Free ^new^

The is an add-on board designed to simplify controlling high-current, high-voltage motors (DC, Stepper, and Servo) using a low-power microcontroller like Arduino. It bridges the gap between the 5V logic of Arduino and the higher voltage requirements of motors. Key Capabilities

While specific clone manufacturers may vary, most HW-130 boards are based on the or similar.

Datasheet for the HW-130 Arduino Motor Shield (Free PDF) hw 130 motor control shield for arduino datasheet free

Automatic shutdown if the chip overheats. 🔌 Pinout & Connections

. It is essentially a clone of the original Adafruit Motor Shield (v1) and is designed to drive DC, stepper, and servo motors simultaneously. Technical Specifications Driver Chips The is an add-on board designed to simplify

HW-130 Motor Control Shield for Arduino: Datasheet and User Guide

The shield uses a shift register to save Arduino pins, requiring only a few digital pins to control all 8 H-bridge directions. Arduino Pins Used Digital Pin 9 Digital Pin 10 DC Motors / Steppers Digital Pins 4, 7, 8, and 12 (via 74HC595) PWM (Speed Control) Pins 11 (M1), 3 (M2), 5 (M3), 6 (M4) Unused/Free Pins Digital Pin 2, Pin 13, and Analog Pins A0–A5 Power Management The HW-130 features a power jumper Datasheet for the HW-130 Arduino Motor Shield (Free

: Remove the power jumper to separate logic and motor power. Power the Arduino via USB or the DC jack. Connect the motor supply to the EXT_PWR terminal block.