Use the "Hold-to-run" mode (Up/Down buttons) to align the rubber door seal with your 1-meter mark.
Using the "Down" arrow button on the panel, press and hold to drive the door down until the bottom rubber profile gently seals against the floor.
handles primary power processing and logic programming. All terminal entries track through specific terminal blocks. crawford cdm9 950 installation manual
Because the Crawford CDM9 950 uses digital encoding, setting the door positions is done electronically through the display panel on the 950 control box, rather than manually adjusting mechanical screws inside the motor. Entering Programming Mode
Industrial safety codes mandate that automated doors stop or reverse if an obstruction is detected. Wire your peripherals to the control board terminal strip: Use the "Hold-to-run" mode (Up/Down buttons) to align
The CDM9 950 can be mounted directly onto the door shaft (shaft-mount) or via a torque arm assembly to the wall or track framework.
Turn on the main power switch. The control panel display will light up, usually showing an unconfigured or error code (e.g., indicating limits are not set). All terminal entries track through specific terminal blocks
Attach the torque bracket loosely to the operator housing. This arm prevents the motor from rotating during operation.
Test all safety devices (photocells, safety edge, and emergency stop) to confirm they interrupt door travel.
Before powering up, manually disengage the door and position it roughly 1.5 meters above the ground.