Remove the plastic spacer from the front brake caliper. Insert the wheel axle into the fork dropouts. Insert the quick-release skewer, adjust the tension nut, and flip the lever closed. The lever should leave a temporary impression on your palm when closed securely.
Follow instructions to properly seat the front wheel and tighten the quick-release lever or nuts.
Check the brake levers. Zpao bikes feature automatic motor cutoff switches inside the brake levers. If a lever is slightly sticky and doesn't snap back fully, it will disable the motor. Clean and lubricate the brake pivots. 6. Regular Maintenance Checklist Zpao Electric Bike Manual
Press and hold the + button for 2 seconds to turn on the integrated headlight and LCD backlight. Press and hold + again to turn them off.
A: You likely have a European or "unlocked" model. Check the label on the motor. If it says "250W," it is legal in the EU (15.5 mph). If "500W," US rules apply. Remove the plastic spacer from the front brake caliper
Check tire pressure (PSI limits are printed on the tire sidewall). Test both front and rear brakes.
Do not operate your Zpao e-bike without first reading the instructions, understanding its performance features, and reviewing all controls. The lever should leave a temporary impression on
: Always start in the lowest power assist mode (Level 0 or 1) until you're familiar with the motor's kick.
Check brake pads for wear. Replace pads if the friction material is thinner than 1mm.
If your Zpao display shows an error code, it typically indicates an issue with a connection.