It specifies strict concrete standards (e.g., minimum 100mm–150mm depth and specific PSI/N/mm² ratings) to ensure stability under heavy loads.
Turn on the lift and listen for unusual grinding, squeaking, or groaning noises. Monthly Maintenance
: Use high-quality chemical bolts or through-bolts, tightened to a specific torque (typically 120 Nm ) to prevent post misalignment. Operational Safety Protocols
The serves as an essential safety and operational blueprint for workshop owners utilizing this legendary 2-post electro-mechanical vehicle lift. Originally engineered by Stenhøj Autolift A/S in Barrit, Denmark, the classic DS2 series is celebrated for its rigid column build, durable trapezoidal screw drive, and twin-motor configuration. Understanding the core maintenance schedules, installation guidelines, and spare parts diagrams outlined in the factory manual is critical to keeping the system running safely while ensuring workshop compliance. Core Specifications & Structural Design
lift, operators must verify the equipment's core layout against the standard specifications found in the Stenhøj Lift Documentation Archive : Standard Specification Typically 3,000 kg (3.0 Tonnes) to 3,200 kg Drive Mechanism Dual-motor electro-mechanical spindle drive Thread Type Cold-rolled trapezoidal spindle with a ∅the empty set ∅the empty set 40x6mm lead Lifting / Lowering Time Approximately 35 seconds Voltage Requirements 3x 230/400V – 50 Hz – 16A 1. Pre-Installation & Foundation Requirements Stenhøj DS2 Go to product viewer dialog for this item. stenhoj ds2 manual
Contact your local Stenhøj agent for specialized, archived documentation for older models like the
is the most important for owners of used DS2 units. Worn threads on load nuts are a common failure point, and the manual provides the necessary specs to monitor the 2mm movement threshold that signals a needed replacement. Are you looking to perform a specific or seeking the installation requirements for a new workshop floor?
The concrete pad must be a minimum of 200 mm (7.8 inches) thick, composed of high-grade concrete (Minimum Class C20/25 or B25).
Check workshop incoming power. Verify all three phases are active using a multimeter. Safety limit switch tripped or stuck arm lock. It specifies strict concrete standards (e
: Built-in switches stop the motors automatically once the lift reaches its maximum or minimum height. Autosfera.lt 3. Operational Guidelines
The Stenhoj DS2 manual is available in various formats, including:
, and a safety nut system that blocks movement if the main load nut fails. autopstenhoj Key Maintenance & Parts Availability
Ten minutes passed. Then twenty.
Warning from the manual: Never change the jumper while the machinery is operational. The output relays may change state unexpectedly.
The robust mechanical nature of the DS2 means problems are often identifiable and solvable with patience.
Stenhøj 2-Post Lift Installation Manual | PDF | Elevator | Concrete
"Here," Elias said, pointing a grease-stained fingernail at a diagram. It was a technical drawing of the hydraulic block. "The pilot valve. Look at the diagram for the lowering sequence." Operational Safety Protocols The serves as an essential
The is a staple in professional workshops, known for its reliability as a two-post electro-hydraulic lift. However, even the most robust machinery requires strict adherence to safety and maintenance protocols. The Stenhoj DS2 manual is not just a booklet of instructions; it is the primary document ensuring the safety of technicians and the longevity of the equipment.
Using the control console to safely raise, park, and lower the load. Maintenance and Lubrication