To use the software, a computer (usually Windows-based) must be connected to the servo amplifier via an RS-232C serial communication cable or USB (depending on the drive model). Install the MRZJW3-SETUP151E software on your PC.
is a Windows-based configuration software designed specifically by Mitsubishi Electric for the MR-J2S series servo amplifiers. It provides a user-friendly graphical interface (GUI) that allows operators and technicians to configure parameters, monitor system status, and perform diagnostics without needing to navigate complex keypad menus on the drive itself. Key Applications
MR-J2S-A (Analog/Pulse), MR-J2S-B (SSCNET Network), MR-J2S-CL Servo Configuration Software Mrzjw3-setup151e
This is a spreadsheet-style list of hundreds of parameters (PnXXX). For example:
If your machine vibrates at low speeds, increase this value from 0 to 0.5ms or 1.0ms. This smooths the current signal but adds lag. To use the software, a computer (usually Windows-based)
: The software provides graphical waveform analysis and status displays, which are essential for tuning the response of the motor to its specific mechanical load. Diagnostics and Maintenance
A built-in virtual oscilloscope allows for high-speed sampling of servo data, helping to visualize responsiveness, identify resonance, and fine-tune PID loops. 3. Installation and System Requirements It provides a user-friendly graphical interface (GUI) that
Auto-tuning gets you 80% of the way. For perfection, use the built-in oscilloscope (usually labeled "Waveform Monitor").
Getting your MR-J3 servo online with the software involves a straightforward hardware connection:
of motor speed, torque, position, and encoder feedback. Tuning of servo gain settings for optimal performance.
When a fault occurs, MR Configurator displays the specific alarm code and provides troubleshooting steps to identify the root cause quickly. C. Advanced Tuning and Test Mode