To automate a charger, route one wire of the charger’s output through the and NO terminals. The relay will close and complete the circuit only when the battery needs charging. ⚙️ Programming and Settings
For long-term use, consider placing the module in a ventilated enclosure to manage any heat generated during relay operation. Calibration: Xh-m608 Manual
Direct output (voltage passes through the relay) Voltage Error: ±0.1V To automate a charger, route one wire of
In P2 mode, use and DEC (-) to set the cut-off value. Save and Exit Hold SET for 3 seconds or wait until flashing stops. 5. Practical Examples Practical Examples Before diving into the manual specifics,
Before diving into the manual specifics, it is crucial to understand what this board is. The XH-M608 is a digital timing control module specifically designed for . Unlike continuous current welders, this board controls the discharge time of high-current capacitors (or a large battery bank) to fuse nickel strips to lithium-ion battery terminals.
The negative terminals (VIN-, IN-, OUT-) share an internal common ground connection on the circuit board. If you want to troubleshoot a specific issue, tell me:
| Parameter | Default Mode (U) | Adjustable Range | Description | |-----------|-----------------|------------------|-------------| | P0 | U | U, P, C, F | Operating mode selection | | P1 | Lower voltage | 0V < P1 < P2-0.1V | Under-voltage threshold | | P2 | Upper voltage | P1+0.1V ≤ P2 ≤ 40V | Over-voltage threshold | | P3 | 0.00 | 0.00 to 9.59 | Timer (HH.MM format) | | P4 | Factory calibrated | n/a | Voltage display calibration |