These faders control the DMX values for the selected fixture.
: Tap MIDI/REC , select a BANK (Up/Down), then press a SCENE button (1-8). The display will flash to confirm. 2. Programming Chases Enter Program Mode . Select a CHASE button (1-6). Select the BANK and SCENE you wish to add as a step.
Located on the left side, these buttons select which lighting fixtures you are currently controlling. Each button assigns a block of 20 DMX channels to that specific fixture. disco 240 dmx controller manual
The Ultimate Guide to the Disco 240 DMX Controller: Features, Setup, and Manual Overview
: 12 buttons to select which lights you are controlling. These faders control the DMX values for the selected fixture
: Ensure you are using high-quality DMX cables rather than standard microphone XLR cables. Add a DMX terminator at the end of the chain.
: Press and hold the PROGRAM button for 3 seconds until the indicator flashes. Select the BANK and SCENE you wish to add as a step
Insert a into the DMX OUT port of the final light to prevent signal ghosting. 🎛️ Manual Operation Mode
Understanding the physical interface is essential before powering on your console. Front Panel Overview