Gordak 952 User Manual Updated Info

Clean the soldering tip using brass wire sponges rather than wet cellulose sponges to prevent thermal shock and micro-cracking.

Keep the workspace clear of volatile chemicals, alcohol-based flux cleaners, and loose paper. Hardware Overview and Interface

Place the unit on a flat, stable surface, ensuring the air intake on the bottom/rear is not obstructed. 4. Operation Instructions A. Hot Air Rework Station Power On: Toggle the main power switch.

200°C – 480°C (392°F – 896°F) Ground Potential (Tip): < 2mV Ground Resistance (Tip): < 2 ohms Unboxing and First-Time Setup gordak 952 user manual updated

If you have lost your physical copy or suspect you have an earlier version, you have several options to obtain an updated one:

Even the best equipment can encounter issues. Here are a few common problems reported by users and how an updated manual or service guide can help:

Turn the dial to the required thermal threshold. Leaded Solder (60/40): 320°C – 350°C Lead-Free Solder (SAC305): 360°C – 390°C Clean the soldering tip using brass wire sponges

This updated user manual provides clear setup instructions, calibration steps, safety guidelines, and troubleshooting techniques to help you maximize the lifespan of your station. 📦 What is in the Box?

Always tin the iron tip with solder before and after use, especially before shutting it down, to prevent oxidation. 5. Maintenance and Tips

Only replace tips when the iron is completely cold. 200°C – 480°C (392°F – 896°F) Ground Potential

Carefully remove the station, iron stand, and hot air gun.

Locate the trimmer hole corresponding to the hot air section.

Choose a nozzle matching the dimensions of the IC component you want to desolder. Secure it tightly using the integrated collar screw.

The nozzle and air produced by the hot air gun can reach extremely high temperatures (