In the Xinje programming software, go to .
The driver is not a separate download but is integrated into Xinje's programming software suite. Follow these steps to obtain it:
If using COM, select the exact COM port number observed in Device Manager.
If you want, I can adapt this into a shorter troubleshooting guide, a checklist for installing Xinje USB drivers, or a version with step-by-step commands for Windows. Which would you prefer?
Typical path for XCP Pro : C:\Program Files (x86)\XCPPro\Driver Check the box for and click Next . xinje plc usb driver install
Plug the Xinje USB programming cable into your computer's USB port. Step 3: Check Device Manager Right-click the Start menu and select . Expand Ports (COM & LPT) or Other Devices .
If Windows does not automatically install the driver upon connection, follow these steps to install it manually: Kylie Jmina USB-XC PLC Programming Cable Instruction Manual
: Try a different USB port (preferably a USB 2.0 port on the back of the PC) or replace the USB cable.
Click . Windows will scan the folder, locate the driver file (often named xinje_usb.inf or similar), and install it. Click Close once the success message appears. Verifying the Connection In the Xinje programming software, go to
This comprehensive guide covers everything you need to download, install, and troubleshoot the Xinje PLC USB driver successfully. Prerequisites Before Installation
Visit the official XINJE forum or contact technical support with the exact error code from Device Manager (right-click device > Properties > General > Status). Happy automating!
Installing the Xinje PLC USB driver is a straightforward process when done correctly. By downloading the official XDPPro software, running the installer as an administrator, and carefully following the setup wizard, you will have a fully functional programming environment. The key to a successful installation is being meticulous about the installation path, having administrator rights, and following the post-installation configuration steps in XDPPro.
After installation, you need to verify the driver is recognized by Windows and then configure XDPPro to connect. If you want, I can adapt this into
: Common for various Xinje interfaces; version 1.0.5.0 is a known stable version for certain legacy hardware.
Plug the 8-pin circular DIN connector into the PLC's programming port. Ensure the PLC is powered on. 3. Manual Driver Installation (If needed)
Because the driver is often unsigned, manual installation through the Device Manager is the most reliable method.
Click or Check Connection . A popup reading "Connection Successful" confirms your system is ready. Configuration in XC_Pro (XC Series) Open XC_Pro . Navigate to Option > Communication Settings . Choose USB as your communication port.
A: For firmware updates and initial IP address setting, USB is often required. Once the PLC has an IP, you can use Ethernet for programming, but USB remains the fallback when network config fails.
To install the USB driver for a Xinje PLC, you typically need to install the (such as XDPPro or XS Studio), which includes the necessary driver files. 1. Identify Your PLC Series Xinje offers different software depending on the PLC model: XC Series : Uses XDPPro software.